Kinze 3600, Operator'S Manual

Page: 81 / 382

6-53 Rev. 7/04
MACHINE OPERATION KPM II STACK-MODE
NOTE: If a discrepancy occurs and digits must be changed, follow STEPS 1 and 2 to enter the programming mode
and proceed as follows:
•Press the OK key and the flashing arrow becomes solid. The least significant digit of the displayed value will be
blinking.
•This value can be changed by pressing either the UP or DOWN arrow keys.
•Once this digit is correct, press the SELECT key and the blinking digit will move to the next significant digit, where
the process can be repeated.
The monitor limits the entry of pulses per mile or kilometer to a minimum of 500 PPM (310 PPKM), and to a maximum
of 500,000 PPM (310,686 PPKM).
KEY Action Flashing Digit Display Value
Press The UP Key Right Most Digit 2031, 2032, 2033
Press The SELECT Key Second Digit From Right 2033
Press The DOWN Key Second Digit From Right 2023, 2013, 2003, 2093, 2083
Press The SELECT Key Twice Left Most Digit 2083
Press The DOWN Key Left Most Digit 1083, 0500 (Min. Value), 9500, 8500
•To reset the counter, press the UP and
DOWN arrow keys at the same time and hold
them down for a short period of time to clear
the data. The CLEAR? icon will be displayed
and the monitor will beep several times.
When the data is actually cleared, the monitor
will emit a long beep, and the total area is
reset to zeros. After the long beep, the
previous recorded total area is not retrievable.
Once cleared, the user may not choose to
exit programming mode without saving as
described in STEP 4.
STEP 4 To exit and save, press and hold the OK key.
The monitor will emit several short beeps
and SAVE? icon is turned on. After a short
time a long beep is heard, and the lower LCD
will display the word “DONE”. Release the
OK key. If the OK key is released BEFORE
the word “DONE” is displayed, the changes
WILL NOT BE SAVED. The word “DONE”
MUST be displayed in order for the save to
have occurred.
NOTE: The programming mode may be exited at
any time, by pressing the SETUP key. Pressing this
key will return the monitor to its normal operation.
All items changed and saved will come into effect
immediately. Any items changed, but not saved will
revert to the original programmed value.
PROGRAMMING - Clearing Total Area
NOTE: Clearing the total area counter will also
clear the field area counter.
STEP 1 To enter the programming mode, press and
hold the SETUP key. The monitor will emit
several short beeps followed by a long
beep. On the lower LCD, the SETUP icon
turns on and the arrow head icon will flash,
indicating that the user can select an item to
program.
NOTE: The monitor must be in a programmable
function (row spacing, units, speed, volume or
area) to enter setup. The monitor will not enter
setup in seed population or seed spacing.
STEP 2 Press the UP or DOWN arrow keys to move
the flashing arrow to TOTAL AREA. As the
arrow icon moves, the lower LCD will display
the current setting of the item selected.
STEP 3 Press the OK key and the flashing arrow
becomes solid and the audible alarm will
sound.
•The lower LCD will display the total area
and the ACRE (or Ha) icon turns on.
•With the flashing arrow on TOTAL AREA,
press the OK key.