Kinze 3600, Operator'S Manual

Page: 52 / 382

MACHINE OPERATION
6-24 Rev. 7/04
UPPER LCD FUNCTIONS
The monitor collects data on the planting rates from all
active rows and calculates an average. This average
will determine the 100% mark. Seed rate for each row
is then compared to the average value and the result is
displayed on the bar graph.
The information regarding each section is displayed
alternately every 5 seconds. While operating a system
with two sections programmed, one or both sections
may be selected any time. When only one section is
selected, the monitor calculates the average based on
the remaining active rows from that section.
STEP 1 Press SELECT key once to show one section.
The flashing icon shows the section that is
not selected. The selected section icon is
continuously displayed on the LCD.
EXAMPLE: The system is setup to display
rear/front sections. Press SELECT key.
The FRONT icon will be flashing and the
REAR section will be displayed on the bar
graph. After 1 minute the front row icon
will stop flashing. The monitor will stay in
this REAR only display through power
down and power up. Each time the monitor
is turned on while in REAR only mode, the
FRONT icon will flash for 1 minute. Also
if seed flow is sensed in the FRONT
section while planting, the FRONT icon
will resume flashing.
(MTR29H)
When the front section is disabled, the
row spacing will automatically double to
maintain the proper implement width in
the monitor. A 23 row 15" configuration
changes to a 12 row 30" configuration
with a touch of the SELECT key.
STEP 2 Press SELECT key again to activate both
sections.
EXAMPLE: Press SELECT key a second
time. The information regarding each
section will display alternately every 5
seconds.
For simple applications, where only one section is
programmed, the display will automatically lock on that
section. Pressing the SELECT key will have no affect.
NOTE: When alternating between two sections, the
display will lock on the section containing the first
recognized alarm until the alarm is acknowledged
by pressing the OK key or the alarm condition is
removed.
KPM II