20
Thermomax Installation Manual
1. Open manifold lid by peeling back
the front seal strip from the lid
section only,
2. Place tube in tube clips on both
support rails.
3. Slide tube into manifold
connection while slightly rotating
tube until washer on bellow sits
flush against manifold fitting. Do
not apply force, if any problems
are experienced, check alignment
of support rails to manifold.
4. Insert tube retaining clip to
secure tube to manifold and
rotate clip 360˚ to ensure a good
connection.
5. Gently pull on tube to ensure
secure assembly.
6. Close tube retaining rubber on
both support rails. Repeat steps 2
to 6 for all tubes.
7. Close manifold lid ensuring
proper engagement of front seal
strip over whole length and on
end caps.
Inserting the tubes
HP400 or HP450 Tubes
1. Open manifold lid by peeling
back the front seal strip from
the lid section only.
2. Place tube in tube clips on both
support rails and close retaining
rubber.
3. Slide the condenser of the tube
through the front seal strip and
into the pocket in the chamber
of the manifold until the washer
on the bellows just touches the
chamber. Ensure the bellow
section remains as straight as
possible.
4. Install all tubes with the same
method and check all the
washers of each tube are in
contact with the chamber of the
manifold.
5. Close lid and press front seal
strip into the manifold lid and
around the end caps.
6. Gently pull each tube to check
the tube has been engaged by
the manifold correctly.
DF400 Tubes
5
1
3
2
6
4
4
1
2
5
3
5
3
7
