19
5
3
1
4
When joining more than one manifold together, it is necessary to use the
interconnection kit which will support and align multiple collectors. Failure to do this
can result in leakage due to stress on hydraulic joints. All manifolds comprise a male
and female connection, enabling manifolds to be connected without the need for
additional pipework. The maximum number of manifolds which may be connected in
series before connecting in parallel is shown in the table below:
1. Insert screws into plate ensuring screws do not protrude to upper side
2. Slide plate approximately half way into channel at bottom of manifold that
is fixed to side rails
3. Tighten up screws to force plate against bottom of manifold (do not overtighten)
4. Slide channel of next manifold on plate
5. Push clip all the way down until connection is fully retained
6. Assemble support rail connection plate to fixed support rails
7. Assemble retaining plates and fittings
Interconnection Kit
7
6
Model
Max. Number of collectors
HP400 x 30 tubes
5
DF400 x 30 tubes
5
