EN
19
EN
In
more
detail...
NMHT18-Li
Operation
General operation
1. Check the product, its battery pack and charger as well as accessories for
damage before each use. Do not use the product if it is damaged or shows
2.
3. Always hold the product on its handles. Keep the handles dry to ensure safe
support.
4. Ensure that the air vents are always unobstructed and clear. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
5. Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete
stop before putting it down.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate
on the work and have full control over the product.
Trimming times
green leaf hedges
June to October
evergreens
April and August
conifers and other fast growing shrubs
every 6 - 8 weeks
Trimming
NOTE:
Try to keep the cutting device angled at approximately 15°
to the cutting surface.
1. Make sure that the blade cover (11) is removed, and the battery pack (12) is
assembled before operation.
2. Ensure that no people or animals are in the work area.
3. Cut and remove branches exceeding the cutting capacity of this product
using a proper pruner before operation.
4.
handle (6). Never operate this product using only one hand.
5. Do not rush and do not attempt to cut too much with one stroke of the cutting
device.
MNL_NMHT18-Li_18V 50cm Hedge Trimmer_V1_210913.indd 19
9/13/21 1:09 PM
