EN
39
EN
In
more
detail...
FPCSP41-3
Product functions
9. Once the engine is running smoothly, carefully pull the front hand guard (9)
back toward the front handle (8) to disengage the chain brake (Fig. 25, step
9).
10. Hold the product with the left hand on front handle (8) and the right hand on
rear handle (1).
11. Press the throttle interlock (2) and then squeeze throttle trigger (3) to
accelerate the engine. The saw chain runs.
NOTE:
If the engine does not start, the engine may be flooded. Flooding
is caused by too much fuel mixture applied at the wrong time and can
prevent a product from starting. Follow below procedure:
Set the ignition switch (23) to “0” position (OFF position). Push the
choke lever (5) fully back to OPEN position. Remove the air filter cover
(6a) and the spark plug (7a) and dry it. Pull the recoil starter handle
(27) for several times to drain the fuel from the combustion chamber.
Wait until fuel vapours and refit the spark plug (7a). Clean up any
spilled fuel and move the product at least 3 metres (10’) away before
starting the engine to avoid any accidental fire. Wait the engine to cool
down and then start the product as described in section “Cold start”.
Stopping
1. Release the throttle interlock (2) and the throttle trigger (3) and let the product
run at its idle speed for 10 – 15 seconds (Fig. 26, step 1).
2. Set the ignition switch (23) to “0” position (OFF position) (Fig. 26, step 2).
1.
2.
2
3
23
Fig. 26
WARNING!
The saw chain (10) will continue to run for short time even
after the engine has been switched off! Wait until the saw chain (10)
has come to a complete stop before placing the product on the ground!
NOTE:
The product will become very warm after a long time using;
allow it to cool down completely before restart. If the product cannot
be switched on with warm start procedure, then refer to the cold start
procedure.
MNL_Petrol Chainsaw_FPCSP41-3_GB_V02_220301.indd 39
3/2/22 11:36 AM