GSM SMS Alarm & Dialer
GSM SOS Call System!
G S M A l a r m S y s t e m .
13
,
03 should be setup as:
.
3)
Enter Leaning Mode
Please press the Learn button, and switch on the K2, after switch on the K2, will alert Di once,
then after enter learning mode, will alert Di
—Di two sounds, total 3 Di sounds(about 5
Seconds), it being learning mode, then loose the button. The learning Button under Pressed
status before switching on the K2 till heard total 3
―Di‖ sound .
The LED of each zone which registered wireless detector or remote control or button will turn on.
Notice:
1)
The K2 cannot exit the learning mode automatically, must switch off the unit then switch on again to enter
the normally mode. The Switch-Combinations for each zone must be active by at least one switch to learning mode
by switch the buttons from OFF to ON, and after learned the correct detector into this position, please switch the
button back to OFF, otherwise the zone will in learning mode all the time.
2)
When learning one detector to the K2, the other wireless detectors must be in OFF status, otherwise will
confuse the learning operation.
4) Learning the Wireless Detector or Remote Control to K2.
When the K2 in the learning mode, then switch the
corresponding switch-combinations
from
OFF to ON one by one, and trigger the wireless detector(see Notice), the K2 will learn the code
from the wireless detector automatically. When alert by long
―Di----‖ sounds, means the wireless
detector was learned to the zone position,
please switch the switches back to OFF.
Meanwhile, please switch off the wireless detector, otherwise will alert by
―Di Di‖ two sounds after
you switch the switch back to OFF. If before switch the switch to OFF then alert by
―Di Di‖ two
sounds, then means the operation failure, please switch them back to OFF then retry again.
Switching the other switch-combinations from OFF to ON one by one to learn the wireless
detectors to other zones..
Notice:
a) Remote Control and Wireless Detectors activated method:
For remote control, press any key then can activate it, no need to press all of them.
The wireless door contact can be triggered by dispatch the two parts when installed battery inside;
The wireless PIR Motion Detectors can be triggered by pass though its front when switched on;
The wireless panic buttons can be triggered by press its button;
The wireless gas leakage or wireless water leakage and wireless smoke detector equips Test Button, press the
Test Button then can trigger them.
The other wireless detectors please reference its user instructions.
