King-Dome 9762-LP, Installation And Operating Instructions Manual

Page: 28 / 44

DISH 1000/1000a for Dish Network HDTV
IMPORTANT! In order for all receivers to work properly, each one must be configured separately while
connected to the MAIN port on the Trac-King.
If you do not have a clear view of all three satellites, the switch will not load.
King Controls recommends using a Dish Network model VIP211 HDTV receiver for
automatic satellite switching.
Note: The SW64 switch is a receiver software configuration that is loaded into the receiver after running a check
switch test with the dish locked on and configured for Dish 1000 or 1000a switching mode.
This is a one time procedure and will not need to be repeated after successful installation, unless the
check switch test is run again while connected to a home dish system, or if you travel to another area and
need to change the selected trio of satellites.
Page 26
Note: Dish 1000 = satellites 110, 119, 129
Dish 1000a = satellites 61, 110, 119
(See map on page 23.)