King-Dome 9762-LP, Installation And Operating Instructions Manual

Page: 12 / 44

Page 10
DOME INSTALLATION AND EXTERNAL WIRING
Fig. 10
Note: The installer is responsible for determining the most appropriate fastener to secure the dome unit to the
roof. Depending on the roof material, fasteners such as lag screws, well nuts, sheet metal screws, toggle
bolts and T anchors may be used, and should always be used in combination with a roof compatible
sealant.
IMPORTANT! The installer is responsible for weatherproofing all holes with sealant.
Make sure power supply is disconnected from 110 volt source before continuing with
permanent installation.
Make sure shipping restraints are removed from bottom of dome unit, and plugs inserted in
appropriate holes (Fig. 5, Page 5 and Fig. 6, Page 6).
Cable connections must ALWAYS be positioned facing the rear of vehicle.
IMPORTANT! USE ONLY THE COAXIAL CABLES SUPPLIED WITH THE KING-DOME.
COIL AND STORE EXCESS CABLE IN THE CABINET WITH THE COMPONENTS. DO NOT
CUT COAX.
If coaxial cable other than that supplied with the King-Dome is used, the following guide
lines must be followed (Fig. 10):
1) Ends must be terminated with SNAP-N-SEAL® connectors.
(DO NOT USE TWIST-ON OR HEX-CRIMPED CONNECTORS.)
2) Cable must be RG6 and rated at 2.2 GHz or higher.