King-Dome 9762-LP, Installation And Operating Instructions Manual

Page: 14 / 44

7. Remove blue protective sheet and red “position to rear” sticker from the dome unit.
Page 12
Fig. 12
TYPICAL ROOF INSTALLATION - OVERHEAD VIEW
IMPORTANT!
Sealant must be roof
compatible.
5. Run coax from the back of the dome unit to the roof edge, then along edge to location
where coax will be fed into the vehicle. (If installing an optional second receiver, run
auxiliary coax to location where it will enter the vehicle.) Secure wiring to roof every 12-
18 inches
(Fig. 12) .
6. Drill 3/4” hole through the roof and into the cabinet where main receiver is stored. Feed
coax down through hole. Seal opening with roof compatible sealant so that it is entirely
waterproof (inside and outside of the 3/4” hole). Fasten cable entry cover to roof. Seal
mounting holes, perimeter of cover and cable opening so they are completely waterproof.
(Fig. 12) .
IMPORTANT! Sealant must be roof compatible.
Installer is responsible for determining proper roof compatible fasteners for cable entry
cover.
Roof holes for cables must be sealed so they are entirely waterproof. Mounting holes,
perimeter of cable entry cover and cable opening of
cable entry cover must be sealed so they are entirely waterproof.