King Controls King Dome 9760 Series, Troubleshooting Manual

Page: 42 / 60

Page 40
SECTION 8
REFERENCE
IMPORTANT! When returning a unit, you must package it in the box from the replacement unit. Use all
included internal packaging, and be sure to attach outer feet removed from new unit.
If you are returning a unit and do not have a King Controls box, call King Controls for a
return shipping box and kit (800 982-9920).
1. Turn rotating bracket to align shipping bolt hole(s) with hole(s) in base.
(Some units may only have one shipping bolt.)
2. Insert shipping bolt(s) thru washer(s) and base and FINGER TIGHTEN into rotating
bracket.
3. Lower dish arm. (Gently push on dish and arm simultaneously. Lower until arm is just
about to touch mechanical stop.)
4. Insert tie strap thru plastic spacer and base, loop around dish arm for 15” models or
through P-clamp for 12” (LP) models, and back through base.
5. Terminate tie strap. (DO NOT OVER TIGHTEN TIE STRAP.)
6. Attach (4) outer feet from replacement unit with lock washers and nuts.
7. Fasten dome cover to base. MAKE SURE YOU ARE USING CORRECT SCREW TYPE.
Tighten screws until washers deform slightly.
RETURN SHIPPING