King Controls King Dome 9760 Series, Troubleshooting Manual

Page: 15 / 60

5. On receiver remote, press MENU 6 1 1.
6. Highlight Check Switch and press Select .
7. Make sure Superdish and Alternate boxes
are NOT checked.
8. Highlight Test and press Select .
The unit will perform a check switch test,
and the dish will periodically move back and forth.
(This process will take several minutes.)
9. When test is complete, SW21 appears
as the installed device, and there must
be no “X”s in the indicated columns.
MUST SHOW
“SW21”
NO “X”s
OPERATION
1. Simply choose your desired channel using the receiver’s remote control. The Trac-King
will automatically switch to the appropriate satellite. (Master receiver only.)
Note: For better performance when using the automatic satellite switching feature, change channels by selecting
your program from the channel guide rather than channel surfing.
Screen graphics may vary.
Page 13
Note on Error Messages: It is common to receive a temporary error message displayed on the TV when the
antenna is switching between satellites or the signal has been blocked. If an error
message appears for an extended period, selecting CANCEL may help clear the
message more quickly.
Note: Loading the SW21 may require several attempts due to geographical area and available satellite signal
strength. If desired results are not obtained, verify there are no line of sight obstructions to the satellites.
(Do this by choosing each satellite individually and verifying the Trac-King locks onto each one.)
Choose DISH 500 again and re-run the test. If test fails call King Controls at (800) 982-9920.