41
Rear
When this function is set to On, the picture will be left/right
reversed. This function is used to project the image from
rear of the screen.
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the back of the projector is switchable for computer input or
monitor output. (See page 9) Select Computer or Monitor Out with the Point
▲▼
buttons.
PC 2
....................Computer 2 Input
omputer 2 Input
Monitor Output
...Monitor Output
Setting
Power management
Time left before Lamp is off.
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off
the projection lamp when the projector is not operated for a certain period.
Select one of the following options:
Ready .................. When the lamp has been fully cooled down, the POWER indicator changes to green blinking.
In this condition, the projection lamp will be turned on if the input signal is reconnected or any
button on the top control or remote control is pressed.
Shut down .......... When the lamp has been fully cooled down, the power will be turned off.
Off ....................... Power management function is off.
Timer ................... If the input signal is interrupted and no button is pressed for more than 30 seconds, the timer
display with No signal appears. It starts the countdown until the lamp is turned off. Use the
Point
▲▼
buttons to set the Timer(1~30min.).
NOTE:
Factory default is Ready: 5 Min.
Auto Power On
This function enables projector auto power on with detection connection with AC power cord.
Ceiling
This function is used to project the image from a ceiling-
mounted projector.
Off
......Disable this function.
Auto ........The picuture will be top/bottom and left/right
reversed automatically.
On..........THe picture will be top/bottom and left/right
reversed.
Rear
No signal
01 : 20
PLC-EN.indd 41
2009-11-17 10:03:29
