b)
The starter pipe is attached to the appliance by placing it over the spigot
on the combustion chamber and locating the mounting flange over the
weld studs that protrude from the top panel on the combustion chamber.
(See Fig. 18 below)
Fig. 18
c)
When the starter pipe is located, tighten the 6 off wingnuts (supplied in
loose items pack) to seal the starter pipe to the combustion chamber.
(See Fig. 19 below)
Fig. 19
d)
Fit the 90 degree elbow in the required direction of the flue pipe (L/H,
R/H or to the rear), and secure to the starter pipe with the clamps as
shown in section 2.9.
16
