Kimble Custom Chassis C6000, Safety Manual

Page: 55 / 106

Section 5 - Operation
5-1 990001-014
SECTION 5 - OPERATION
5.1 ENGINE
Starting the Engine
This vehicle can be operated under normal conditions in temperatures of -32° F to
110° F (-35° C to 43° C). Consult Kimble Custom Chassis for operation outside this
range or under abnormal conditions.
1. Make sure shifter is in “Neutral” and all electrical components (lights, heater,
defroster, etc.) are turned off. Ensure parking brake is set.
2. Turn ignition switch to “START” to engage starting motor. Release key
immediately when engine starts. If engine fails to start within 15 seconds,
release key and allow starting motor to cool for a few minutes before trying
again.
3. After engine starts, observe engine oil pressure gauge. If gauge remains on
zero for more than ten seconds, stop engine and determine cause before
restarting engine. Reference engine manual for minimum pressure at operating
temperature.
4. Allow engine to idle, increasing air pressure within the air brake system
reservoir.
Note: Engine will not start unless transmission is in “Neutral” and park brake
applied.
CAUTION
EQUIPMENT DAMAGE Failure to allow starter to cool could result in serious
damage or premature failure of the starter motor. Do NOT engage the starting
motor when flywheel is turning.
WARNING
UNEXPECTED MOVEMENT HAZARD. Always ensure that transmission is in
neutral and the service brake is applied before releasing park brake. Releasing
park brake in either forward or reverse could cause the vehicle to move abruptly,
causing an accident resulting in death or serious injury.