Sirius Capacitor Module
–
User Manual
Model Number - 3550-48-B-1.7C-M-SD-A-L-19G
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
40
your Reseller for calibration procedure.
Q. What is the reason if the LED isn’t working at all?
A. Due to different reasons that may happen such as:
•
If we can get the output (Terminal, software communication), the LED may have some technical
issues.
•
The protected terminal is not working.
Please consult with your Reseller.
Q. How to troubleshoot the communication between the Module and PC?
A. If you face any communication difficulties between the Module and PC please troubleshoot as
follows:
•
Double Check the cable connection (try to use anther USB cable).
•
Try to use anther port in the PC.
•
Check the Module USB drive in your PC from setting then search for Device Manager then go to
ports as shown below (Please refer to USB serial driver quick install).
After the troubleshooting if the problem still doesn’t solve, please
consult with your Reseller.
Q. The Module is showing Contact Service.
A. Contact your Reseller for customer support.
Q. How to update the Firmware.
A. New Firmware is uploaded to
https://www.amberandwaseem.com/
.Always check the website for
an update.
Q. The Module doesn’t seem to show correct State of Charge (SOC).
A. The Module is using the previous data to correct the state of charge in the long run. Charge the
Module to maximum Voltage and then discharge it to cut-off Voltage and repeat the process several
times to correct the SOC. Note that open voltage is not directly related to SOC.
Figure:
Module Port
&com number
