Sirius Capacitor Module
–
User Manual
Model Number - 3550-48-B-1.7C-M-SD-A-L-19G
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
17
9.
F12 Terminals:
These are the output terminals of the Module having electronic switch protection that is limited to
100VDC only.
F12 terminals are used to connect the load or charger to the Module. There are also
positive and negative cables in the jumper cable set. The
red
one is positive (+), the
black
one is
negative (-).
3
Tilt Sensor:
Sirius Module has Anti-theft control feature, for this purpose a tilt sensor is used which detects the
inclination of the Module. Module will ask for password when Switching it ON or after it is tilted. The
maximum angle of tilt is 45 degree.
4
Module Installation:
4.1 Inspection:
Inspect the shipping carton for visible damage including cracks, dents, deformation and other visible
abnormalities prior to unpacking the Module. Document (photograph) any damage and report this to
your Reseller as well as to the shipping agent immediately. Remove the Module from the shipping
carton and retain the shipping materials until the unit has been inspected and is determined to be
operational.
4.2 Safety Gear:
Installation must strictly follow the national safety regulations in compliance with the enclosure,
installation, creepage, clearance, casualty, markings and segregation requirements of the end-use
application. Installation must be performed by professional installers only. Switch OFF the system and
check for hazardous voltages before altering any connection! Sirius Modules must be handled only by
qualified and trained personnel. Installation should not exert bending or twisting torque to the Module
enclosure.
Note!
Read the safety Instruction section before installation.
Never connect the red cable to the negative terminal of
the Module.
