Sirius Capacitor Module
–
User Manual
Model Number -7100-48-B-2C-M-SD-A-FL
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
23
Cause of Shutdown
LCD Warning Message
Description
Over-Current (OCD)
When the module has an Over-current fault,
the counter counts for 5 seconds and if the
current does not drop lower than the cut-off
and count down reaches zero, the buzzer
alarms and the protected terminal will shut-
down.
Module Charge Full
When the Module has reached the
maximum voltage, the protected terminals
will shut down. This means that each cell
from the module has reached maximum
rated charge.
The event can be repeated if the charger is
still ON and operating in the same condition,
the buzzer alarms and LCD will show the
warning message.
Low Charge Module
When the Module reaches the minimum
voltage and it is in standby mode, the LCD
will display this message every 30 seconds.
When the Module has reached the minimum
voltage and the Module is connected to a
load, the buzzer alarms, protected terminals
will shut down and LCD will display the
message.
Over-Temperature
When the Module has an Over-Temperature
fault, the buzzer alarms, the protected
terminals will shut down and LCD will display
the message.
Terminal Over
Temperature
When the Module has a terminal Over
Temperature fault, the buzzer alarms,
the protected terminals will shut down and
LCD will display the message. This means that
electronic switch has reached 80oC.
10.
Trouble Shooting
Check the indicators on the front to determine the state of the Module. A warning state is triggered
when a condition, such as voltage, current or temperature, is beyond design limitations. When the
Module falls outside prescribed limits, it enters a warning state. When a warning is reported, the
Module immediately stops operation.
The possible warning messages are as follows:
