Sirius Capacitor Module
–
User Manual
Model Number -7100-48-B-2C-M-SD-A-FL
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
15
5.
Operation Procedures
5.1
Module Setup
Follow the steps below to switch ON the Module.
Step 1: Connection of Cables to Anderson Connectors
First connect the Anderson Connector to the Cables of the Module, by following the steps below:
•
Take Anderson Connector as shown in the picture.
•
Strip the insulation from the cable and gently twist the wire strands to keep them in contact (as
shown in pic below).
•
Put the wire strands into the Anderson connector lugs and crimp tightly down. Once crimped,
pull the connector to make sure it is firmly attached to the wires. After crimping, the connector
is as shown in the picture.
