Sirius Capacitor Module
–
User Manual
Model Number -7100-48-B-2C-TM-SD-A-G
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
26
Over-Temperature
When the Module has an Over-
Temperature fault, the buzzer alarms, the
electronic switch will shut down and LCD
will display the message.
Terminal Over
Temperature
When the Module has a terminal Over-
Temperature fault, the buzzer alarms, the
electronic switch will shut down and LCD will
display the message.
This means that electronic switch has
reached 80
o
C.
8.
Trouble Shooting
Check the indicators on the front to determine the state of the Module. A warning state is triggered
when a condition, such as voltage, current or temperature, is beyond design limitations. When the
Module falls outside prescribed limits, it enters a warning state. When a warning is reported, the
Module immediately stops operation.
The possible warning messages are as follows:
Warning Messages
Description
Trouble Shooting
Over-Current (OC)
OC occurs when the current
goes above 296A or when the
Module is short-circuited. In
this event, the electronic
switch will shut down.
Switch OFF the circuit breaker and
check the continuity across the
Module terminals to find whether
there is a short circuit. In case of a
short circuit, check the operating
circuitry and clear the short circuit.
Over-Temperature (OT)
OT occurs when the Module
temperature
goes
above
80°C. In this event, the
electronic switch will shut
down.
Shut down the Module and check
the surrounding temperature and
ensure the ambient temperature is
less than 80°C. If not leave the
Module to cool till the temperature
comes below 80°C. Now, turn ON
the circuit breaker.
Please Remove Charger/ Please
Connect Charger
This happens when there is
some residual current. In
this event, the Module gives
alarm for full charge or low
charge
and
the
charger/discharger is also
disconnected
but
the
electronic switch is not
In Sirius VIEW application, select
Sirius Config then go to Calibrate
Zero Current. Press Calibrate. If you
see “No load current i
s set
successfully”, it means the current
is set to zero.
