Sirius Capacitor Module
–
User Manual
Model Number -7100-48-B-2C-TM-SD-A-G
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
25
3.
Turn OFF the bypass breakers of all Modules.
7.
Automatic Safety Shutdown
The Module will automatically shut down under any excessive use conditions in order to prevent damage to
itself and to the connected equipment. Specified limits for excessive current, high voltage and low voltage are
provided in Module’s technical data sheet.
Cause of
Shutdown
LCD Warning Message
Description
Over-Current (OCD)
When the Module has an Over-current
fault, the counter counts for 5 seconds
and if the current does not drop lower
than the cut-off and count down has
reached to zero, the buzzer alarms and the
electronic switch will shut-down.
Module Charge Full
When the Module voltage reaches the
maximum voltage, the electronic switch
will shut down. This means that each cell
from the Module has reached to
maximum rated charge.
The event will be repeated if the charger
is still ON and operating in the same
condition, the buzzer alarms and LCD will
show the warning message.
Low Charge Module
When the Module is in standby mode and
it reaches the minimum voltage, the LCD
will display this message every 30
seconds.
When the Module is connected to a load
and it reaches the minimum voltage, the
buzzer alarms, electronic switch will shut
down and LCD will display the message.
Warning:
Not following the steps in sequence may damage the Module.
