Sirius Capacitor Module
–
User Manual
Model Number -7100-48-B-2C-TM-SD-A-G
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
14
6.
COMM Connector USB:
This is a COMM connector to monitor the Module using the Sirius software. FTDi chip is used for this USB.
7.
COMM Status LED:
COMM Status LED indicates the communication status.
•
LED Status Indication:
Color
Status
Indication
Red
Blinking
Control Module is communicating with Sirius VIEW Software.
Red
Steady
Control Module is not communicating with Sirius VIEW
Software.
Red
Dimming
Module is in power down state.
8.
Terminal Status LED:
Terminal status LED indicates the F12 terminal status.
Color
Status
Indication
Green
ON
The F12 terminal is active
Green
OFF
The F12 terminal is not active.
9.
F12 Terminals:
These are the output terminals of the Module having electronic switch protection that is limited to 100VDC
only.
F12 terminals are used to connect the load or charger to the Module. There are also positive and negative
cables in the jumper cable set. The
red
one is positive (+), the
black
one is negative (-).
3.
Module Installation:
3.1 Inspection:
Inspect the shipping carton for visible damage including cracks, dents, deformation and other visible
abnormalities prior to unpacking the Module. Document (photograph) any damage and report this to your
Reseller as well as to the shipping agent immediately. Remove the Module from the shipping carton and retain
the shipping materials until the unit has been inspected and is determined to be operational.
Never connect the red cable to the negative terminal of
the Module.
