Sirius Capacitor Module
–
User Manual
Model Number -7100-48-B-2C-TM-SD-A-G
This manual is subject to change without notice and at the sole discretion of Kilowatt Labs, Inc.
Kilowatt Labs, Inc. |
17
3.
Wait till the LCD screen on the Module displays initial values.
4.
Be sure you are able to see the terminal status LED
OFF
.
5.
Press and hold the fault reset button, after 3 seconds the terminal status LED will change to Green.
6.
Release the fault reset button.
Step 3: Module Shut-Down:
1.
Press and hold the fault reset button to turn
OFF
the terminal. After 3 seconds the terminal status LED will
go
OFF
.
2.
Make sure every indicator on the Module is
OFF
.
3.
Turn
OFF
the Module by moving the Circuit breaker button to the
OFF
position.
4.2
Software Configuration:
To configure Sirius VIEW application, please follow the steps below.
1.
Install the Sirius VIEW application on your system.
2.
Connect the USB cable to the COMM connector USB slot to start communication and monitoring.
3.
Turn on the Sirius Module by pressing the fault reset button on front panel.
4.
Wait till the LCD screen on the Module displays initial values.
5.
Double click on the Sirius VIEW application to execute it.
Note!
Use the Bypass circuit breaker button to connect the Modules in Series
and for recovery purpose.
Note!
Always turn OFF the Module when not in use because it is Self-
Powered. If left ON, the self-discharge rate will increase.
Note!
Due to shipping laws and regulations, the Module may be shipped in
partial State of Charge.
