Kilews KL-TCG, User Manual

Page: 9 / 16

8
6. Screw setting
Name
Set Up
Value
Function Description
Default
setting
Tightening Program 01~99 Setup screw parameter. 01
Screw Name ****** Setup screw parameter name. It can choose
number
、
capitals and lower case letters
、
number.
******
Step 1 001~250 Setup 1 st sequence 01
Step 2 000~250 Setup 2 nd sequence 00
Step 3 000~250 Setup 3
rd
sequence 00
Step 4 000~250 Setup 4
th
sequence 00
Step 5 000~250 Setup 5 th sequence 00
OKALL Alarm Time 0.0~9.9 AT
：
OKALL signal holding time 1.0
OK Time 0.0~9.9 OT
：
OK signal holding time 9.9
NG Stop OFF
1~9
Disable screwdriver when error occurred.
1~9
Setting value “1” means the screwdriver will be locked
when an error occurs.
Setting value “2” means when two consecutive errors
occurs will lock the screwdriver.
Setting value “3” means when three consecutive errors
occurs will lock the screwdriver…and so on. If the
tightening status is OK once, it will be recalculated
。
ON: When malfunction signal
『
NS
』
happens, it will
disable screwdriver immediately
；
User need to press
『
ENTER
』
button to deactivate rotation(For I/O part.
But screwdriver can reverse.)
OFF: When malfunction
『
NG
』
happen, screwdriver will
not stop
；
it will not affect next activation. It will provide
a warning
OFF
OKALL Stop OFF/ON Disable screwdriver when batch completed
ON: Stop screwdriver after batch completed. Users need
to press
『
ENTER
』
(For I/O part, it is confirm signal)
OFF: Screwdriver is normal after batch completed.
OFF
7. Extra function
Name Function Description
Export to SD Card Export to controller internal setting value(Controller setting
、
Program setting
、
Screw setting)
Calibrate Tool Calibration mode