16
PWR Series Setup Guide
Connecting the Load
Connecting to the Output Terminal on the Rear Panel
WARNING
Possible electric shock. Be sure to turn the POWER
switch off before touching the output terminal on the
rear panel. Be sure to attach the OUTPUT terminal cover
after wiring the load.
The chassis connection wire is not included. If you are using the
chassis connection wire that comes with the analog remote control
connector kit (OP01-PAS), you can use it immediately as it is al-
ready assembled.
1
Turn the POWER switch off.
2
Connect the chassis terminal to either the - (neg.) or + (pos.)
output terminal using the chassis connection wire.
The output terminal has an M3 hole used to connect the
chassis connection wire. If you are not using the optional
OP01-PAS, attach a crimping terminal to a wire of AWG18
or higher to make the connection.
This M3 screw is fastened to the + (pos.)
terminal before factory shipment. If you want
to connect the chassis connection wire to the
- (neg.) output terminal as shown in the
figure, change it as such.
M3 screw
3
Attach crimping terminals to the load wires.
The output terminal on the rear panel has M4- (with taps)
and M8-sized holes for connecting the load wires. Attach
the crimping terminal that matches the screws.
Use crimping terminals that are less than equal to 5.5 mm
2
with the M4-sized holes.
4
Connect the load wire to the output terminal on the
rear panel.
If you are using M8 screws, pay attention to the direction of
the screws.
Connection using M4 screws
Connection using M8 screws
If you do not connect the wire as
shown, the OUTPUT terminal cover
may hit the M8 screw.
Do not fasten M4 screw without
attaching the load wire. Otherwise
the threads of the output terminal
may be damaged.
M4 screw
Crimping
terminal
M8 crew
Crimp terminal
Spring
washer
Nut
