PWR Series Setup Guide
11
Inrush current
An inrush current flows when the POWER switch is turned on. If you
are planning to use several PWRs and turn on their POWER switch-
es simultaneously, check that the AC power line or the switchboard
has sufficient capacity. For the inrush current of each model, see
“Specifications” of the user’s manual on the accompanied CD-
ROM.
Turning the POWER switch off
Push the (
○
) side of the POWER switch to turn the PWR off.
The PWR stores the panel settings (excluding output on/off condi-
tion) immediately before the POWER switch is turned off. For these
items, the PWR starts up using the settings that existed when the
POWER switch was turned off the last time.
If the POWER switch is turned off immediately after changing the
settings, the last settings may not be stored.
CAUTION
When turning the POWER switch off and then back on, allow
at least 10 seconds after the panel display lights out. Repeat-
ed on/off of the POWER switch at short intervals can cause
damage to the inrush current limiter and shorten the service
life of the POWER switch and internal input fuse.
Turning the Power On
