A
Page 12 / 30
Product Description
RPW404P-FTL
Datasheet 1.10-65.030-01-EN
Issue 2017-04-03
“Test installation location” function
The room control module provides assistance in selecting the optimum installation location.
This function is active after switching on the device (see the “Switching the Device On/
Off” section page 11), provided a radio partner has not been registered (for a
maximum of 15 minutes).
The text “
InSt
” is displayed.
►
Switch on the room control module, see p. 11.
The display switches on. Symbols "Sun“ and "Occupancy“ and the text "
InSt
" are displayed. The
occupancy sensor and the solar cell are active.
►
Position the room control module at the potential installation location.
►
Check the “Sun” icon on the display.
►
Move about in the room and check the “Occupancy” icon.
►
Once a suitable installation location has been found, the room control module can be mounted
and commissioned.
NOTE
If a radio partner has not been taught-in after 15 minutes, the room control module automatically
switches off.
NOTE
If the energy storage unit is empty, the “Sun” icon will not appear even if the location is good. The
energy storage unit must be charged first. Charge the energy storage unit by placing the room control
module in a source of light for two hours (day light or artificial light, but not direct sun light).
Occupancy sensor
The room control module automatically detects a presence in the room with its occupancy sensor.
Depending on the distance, the range of movement in the detection area is important. The further a
person is away from the occupancy sensor, the greater the movement must be.
Evaluation
Display
Installation location
good
The “Sun” icon is permanently displayed and
the “Occupancy” icon switches from “Person inside the house” to “Per-
son outside the house” and back again
Installation location
bad
The “Sun” icon is not displayed or
the “Occupancy” icon does not switch to “Person inside the house” and
remains unchanged.
0 m
1 m
2 m
3 m
4 m
5 m
8 m
7 m
9 m
6 m
1,5 m
