Kieback & Peter MD10-FTL-HE, Quick Start Manual

Page: 17 / 44

17
/44 Commissioning
|
en:key
You want to bond or screw the wall mount to a wall.
► 1
Push in the bar on the wall mount and slide the wall mount down on the room
sensor.
2
Remove the “wall mount” from the room sensor.
3
Hold the “wall mount” in place at the installation location.
4
Mark the position of the “wall mount” or the positions of two opposite
mounting holes on the wall.
Item Designation Explanation
01 Adhesive pad Bonds the wall mount to even surfaces
02 Fastening material Select based on surface
(Not included in scope of delivery)
03 Adhesive digits Identifies room sensor and wall mount
04 Holding bar Holds the room sensor in place on the wall mount
05 Wall mount Room sensor wall fastening
For a lasting bond, remove any dust and grease from the adhesive surfaces
on the wall mount and the wall.
Position the wall mount so that the bar can be easily accessed. Ensure a dis-
tance of at least 10
cm from other objects (door frames, electrical sockets,
cupboards, etc.).
Observe the alignment of the wall mount. The bar must be mounted on the
lower right side.