Troubleshooting
IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions
Guide below. If you still experience a problem, please contact our Service Center, at
1-909-643-9359
from 9 AM to 5 PM (
PST) Monday through Friday. Or email us [email protected] or
visit us
www.funcreation.net for assistance and information from our trained technical staff.
Problem
Car does not move
Circuit breaker tripped
Loose wire or connectors
Dead battery
Undercharged battery
Charger is not working
Damaged switch
Loose wire or connectors
Circuit breaker tripped
Car was running but
suddenly stopped
Possible Cause
Solution
Circuit breaker may "trip" and stop the vehicle if it is overloaded or the
driving conditions too severe. The breaker will automatically reset after
approximately 10 seconds, and the vehicle will operate normally. To avoid
repeated automatic shut downs, do not overload the vehicle by exceeding
the weight limited of 30kg (66 lbs). Or by towing anything behind the
vehicle. Do not drive up hills or run into fixed objects, which can cause the
wheels to stop spinning while power is still being supplied to the motors. If
breaker continually trips, please contact our Service Center.
Check all wires and connectors. Make sure that the motor harness
connector is plugged in tightly to the battery, and that there are no
loose wires around the motor.
An old or improperly cared battery may be dead. If you are unsure
whether it is dead or not, you can have it tested at our Service
Center.
A new battery should have been charged for at least 12 hours before
using the vehicle for the first time. After that, it must be recharge the
battery for at least 9-10 hours after each use. Never charge longer than 15
hours. Check all connectors; make sure the charger is plugged into the
wall. Make sure the power flow to the outlet is on.
You must have a volt meter in order to tell whether the charger is working
or not. If you think there maybe a problem with the charger, take it to the
our Service Center where they will test it for you.
When exposed to water or moisture, switches can become corroded,
or can jam due to loose dirt, sand or gravel.
Please contact our Service Center for diagnosis and repair.
Code - matching
If the remote control cannot start the car, please check whether the remote
control code-matching function is normally operated.
Check all wires and connectors. Make sure that the motor harness
connector is plugged into the battery tightly, and that there are no loose
wires around the motor.
Circuit breaker may "trip" and stop the vehicle if it is overloaded or
the driving conditions too severe. The breaker will automatically reset after
approximately 10 seconds, and the vehicle will operate normally. To avoid
repeated automatic shutdowns, do not overload
the vehicle by exceeding the weight limited of 30kg (66 lbs), or by towing
anything behind the vehicle. Do not drive up hills or run into fixed objects,
which can cause the wheels to stop spinning while power is still being
supplied to the motors. If breaker continually trips, please contact our
Service Center.
Replace batteries
Check whether the remote control battery power is low.
Troubleshooting
I
15
Summary of Contents for BMW M6 GT3 1207
Page 19: ......
