Assembly
Install the seat and seat back
Install the windshield and the empennage
Open the car door
8
8
16
16
1
9
9
16
16
2
After the power supply is installated, put the
seat (part 8) into the assigned location of the
car body, and fix it with two screws (part 16).
Put the seat backrest (part 9) into the assigned
location of the car body as shown in the figure above,
and tighten it with two seat backrest screws (part 16).
10
2
2
1
2
Install the windshield (part 2) to the specified
location of the car by fixing the position of
each buckle and press until it is firmly fastened.
Insert the spoiler (part 10) at the direction shown
by the arrow, and press the buckles firmly until
it is fasten.
Press the
switch button
Press switch button outside the vehicle door sheet,
then pull the vehicle door open.
22
2.4G remote control
Screw open the battery cover, place two “AAA”
batteries into the battery compartment with correct
polarity. Place back and fasten the battery door.
The fixing glue meson
on the screw can
prevent the screw
from dropping out
Battery Cover
2 × 1.5V AAA Batteries
(not included)
Battery
Compartment
Installation and replacement of remote control batteries
Assemb
ly IV
11
Summary of Contents for BMW M6 GT3 1207
Page 19: ......
