Onaga Rocket Kohaya
B28-VSF-006
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the sides, struts and support plates (shown
above) from the sprue.
Stick the support plates to the reverse side of a side
piece as shown above. The arrow should point
towards the front of the ship.
The same pieces shown from the other side
–
showing the position of the notch.
Attach the other side piece and slide the support
struts into place.
Take the main deck and
“
wall
”
from the sprue.
Attach the deck using the holes / lugs provided.
Glue the
“
wall
”
into position. Allow to dry.
Take the base plate and prow sections from the
sprue.
Summary of Contents for Onaga Rocket Kohaya
Page 6: ...The completed model...
