SHOCK CORD
MOUNT
SECTION
3
SECTION
2
SECTION
1
ESTES® INDUSTRIES
1295 H Street
Penrose, CO 81240
PRINTED IN CHINA
www.estesrockets.com
SUPPLIES REQUIRED:
ALL GLUED AREAS ARE SHADED IN GRAY
HOBBY KNIFE
PLASTIC
CEMENT
CARPENTER’S
GLUE
PENCIL
RULER
SCISSORS
FINE
SAND PAPER
(#400-600 GRIT)
MASKING
TAPE
FLYING MODEL ROCKET KIT INSTRUCTIONS
HELPFUL HINT: IF NOSE CONE/COUPLER FIT IS. . .
TOO
TIGHT
TOO
LOOSE
ADD
MASKING TAPE.
SAND FOR FIT.
Black Engine
Holder Ring (1)
(30120-3)
Blue Engine
Mount Tube (1)
(30326-1)
Fin Unit (1)
72614
Launch Lug (1)
(38175)
Red Tube
Coupler (1)
(30174-5)
Decal Sheet (1)
(60160)
Assembled 12” (30 cm) Parachute
(35801)
Lower Body Tube - BT-50 (1)
(60158)
Upper Body Tube - BT-50 (1)
(30349)
Nose Cone (1)
(71027)
Green Engine
Block (1)
(30162-2)
PARTS:
Locate the parts shown below and lay them out on the table in front
of you. DO NOT USE THIS DRAWING TO ASSEMBLE YOUR ROCKET.
KEEP FOR FUTURE REFERENCE.
SPRAY CLEAR
COAT
(OPTIONAL)
NO.2
Green Adaptor
Ring (1)
(30165-2)
ASSEMBLY TIP
Read all instructions before beginning work on your model. Make sure
you have all parts and supplies. TEST-FIT ALL PARTS TOGETHER
BEFORE APPLYING ANY GLUE. If any parts don’t fit properly, sand
as required for precision assembly.
FOR KITS:
EST 1235
EST 1260
Engine Hook (1)
(35021)
Shock Cord (1)
(38374)
