3. Bike set assembly
3.1 Tow bar
The box of the tow bar contains the
following items:
1. Tow bar with remounted stainless
steel ball
2. Cog A, B, C,D
3. Plastic ring (Use only with quick-
release axle)
4. Axle ring (use only with cog C and
D)
5.3 Connecting the tongue
Remove the locking pin (B) before
connecting the tongue (A). Move the
tongue through both tongue holders (C).
Push the tongue through until the end
aligns the black line on the frame. The
curve of the tongue must be on the left-
hand side.
2.6 Detachable side windows
The KID CAR Comfort has been fi tted
with 2-in-1 rain and mosquito mesh
side windows. Zip fasteners are used to
open and close the windows, allowing
even more fresh air for the children. The
unique design has made the windows
interchangeable, so there is no need to
mark the left or right side window.
Tip! You may also wish to unzip the
window half open and fold the front
inward, allowing fresh air but without
any draught around the children’s
heads.
5
2.5 Complete front cover
It is also possible to fully roll up the front
cover. Roll the cover from the bottom
up. Make sure that the ribbon is not also
rolled up, but is laying loose instead.
Run the ribbon from the back over the
front cover and through the ring that is
now showing below the cover. Pull the
ribbon tight and secure with the Velcro.
The cover may have to be pushed a
little further to the back to be adequately
secured.
Always assemble the tow bar on the left
side of the bicycle on the rear axle. Install
the tow bar according the instruction
supplied with the tow bar.
(A)
(C)
(C)
(B)
With the tongue positioned in both
holders, push the locking pin through
the rear tongue holder and tongue.
Attention: Make sure that the locking
pin runs through the bottom and top
of the tongue holder.
Removing the tongue
After removing the tongue, replace the
locking in the tongue holder.
3.3 Tongue with rapid-action coupling
The patented rapid-action coupling
with the tongue gives an immediate
connection of the KID CAR to the bicycle.
The ball ensures that the KID CAR and
the bicycle can move independently from
one another.
Connect the coupling to the ball on the
tow bar by pulling the ring of the locking
mechanism (1) up, and simultaneously
turning the lower part of the coupling
clockwise (2).
The coupling will now fi t around the ball.
Turn the lower part of the coupling back
(2). The locking pin will fall in the locking
mechanism by itself.
Pull the safety belt through the frame of
the bicycle and strap the belt with the
buckle on the tongue.
Attention! Always secure the tongue
with the safety belt.
3.4 Safety fl ag:
The safety fl ag makes riding a bike
safer for you and your children. The
fl ag fl ies above the traffi c. The swinging
movements of the fl
ag signal your
presence with the KID CAR to other road
users. Therefore, always use the safety
fl ag when you go for a bike ride with the
KID CAR.
Fold the spring clip of the locking pin
up ward so the tongue is locked. Check
whether the tongue is secured by moving
the tongue forward and backward while
blocking the KID CAR.
