1.2 Assembly of the back
Assembly of the back of the Cocoon
The back of the KID CAR Cocoon is to be
tightened using four adjustable straps.
Stretch the back across the cross tube
as shown in the illustration and connect
the corresponding buckles. Tighten the
seat by pulling the straps down. When
folding the Cocoon away, unlock the
buckles and follow the above directions
in reverse order.
Assembly of the back of the Comfort
The Comfort has a fi xed back, kept
in place by guide plates and butterfl y
knobs. First turn the butterfl y knobs
from the adjustment plates. Tilt the back
backwards until the guide plates make
contact with the adjustment plates.
Turn the butterfl y knobs back into the
adjustment plates.
Do not completely remove the butterfl y
knobs when adjusting the back. Just
loosen the butterfl y knobs until the back
can be changed to a different position,
and retighten the knobs.
The butterfl y knobs must be completely
removed before folding the Comfort
away. This will allow you to fold the
back forward. To make sure you will not
lose any parts, we suggest you put the
butterfl y knobs back into the adjustment
plates before you continue to fold the
KID CAR Comfort away. Follow the
remaining steps in reverse order.
1.3 Installing the wheels
Slide the axle shafts of the wheels into
the axle holders. Push the locking pins
in the appropriate holes and secure the
interlocking device;
Finally, put the hub caps onto the wheel
hubs. The hub caps are in the parts box.
On the inside of the hub caps are three
little studs. Place these studs in the
corresponding holes of the wheel hubs.
Turn the cap clockwise for the cap to
tighten itself.
1.4 Stroller wheel
To attach the stroller wheel, slide the pin
from the bottom into the holder. Secure
the pin using the locking pin that fi ts in
the hole of the pin.
Before using the KID CAR as a bike
trailer, the stroller wheel must be
stowed away in the appropriate space
on the right-hand side of the fl oor edge.
Slide the pin through the tube with the
swivelling wheel pointing up. This will
keep the stroller wheel in place by the
fl oor edge. Push the locking pin through
the hole of the locking pin to secure the
stroller wheel.
1.5 The front cover
The front cover is kept in place by an
adjustable strap that holds the cover
tight between the two roller cage
parts. Unroll the front cover and move
the back section forward to make the
adjustable strap visible. Spread the front
cover across the roller cages as in the
illustration.
Guide the end of the adjustable strap,
from the top down, through the plastic
rings of the roller cage on either side.
Make sure that the cover is reasonably
centred. Pull the left and right-hand side
tight and secure with Velcro.
3
