INSTALLATION INSTRUCTIONS
Wall S leeve Brands:
#4 General Electra/Hotpoint 16
Deep
1. Rem ove existing rear grille as shown on Page
6 of this manual and replace w ith provided
louvered rear panel. Install as shown here.
You may need to drill holes in flange of
existing sleeve to match new rear grille.
NOTE:
78
/
2. Cut (2) 17 Tapered Spacer Blocks as shown
below into two pieces.
3. Install 13 section as shown with the tapered end
from the back of the sleeve. This helps induce a
rear ward s lop on the unit.
4. Attach (1)1
x3/8 x25 long seal in the center
at the top of the sleeve. Remove the backing
paper and press into position.
5. Attach (2) 1
x3/8 x14 seals to the left and
right sides of the sleeve.
6. Cut (2) 1
x3/8 x 25 long seals to 14 long
and attach it to the vertical sections of the rear
grille as shown.
7. Center unit and gently slide unit into sleev e.
8. Before sliding all-the-w ay back, rem ove 2nd
screw from front on left side of unit.
9. Rem ove the plastic washer from the screw.
10. Scr ew and attac h the other end of the ground
wir e to the unit as shown in picture. Make sure
that the toothed washer is against the cabinet.
11.Slide the unit completely to the rear to ensure
a good seal, making s ure the ground wire does
not become tangled.
12.Seal & Fr ame the unit as described on page 17.
13. If you have difficulty with mounting the grill to
the sleeve, follow the instructions for direct
mounting on P age 16.
1
/
2
3
/
4
17
Tapered Spa cer Block
1
Protectio n Paper
Backing
Cut Here
13
4
4
3
8
3
8
10
