INSTALLATION INSTRUCTIONS
Wall S leeve Brands:
#7 Whirlpool
( 23 Deep)
1. Remove existing rear grille as shown on Page
6 of this manual and replace with pr ovided
louvered rear panel. Install as show n here.
You may need to drill holes in flange of
existing sleeve to match new rear grille.
NOTE:
2. Place (2) 1
x1
x14 seals against eac h side.
3. Gently slide unit in and check if amount extend-
ing from the sleeve is sufficient once the trim
frame is attached.
4. If position is Ok , remove unit and proceed to
the next s tep. If not go to step 9.
5. Attach (1)1
x1
x25 long seal in the c enter
at the top of the sleev e. Remove the bac king
paper and pres s into position.
6. Attach (2) 1
x1
x14 seals to the left and
right sides of the sleeve.
7. Cut (2) 1
x
x25 long seals to 14 long
and attac h to
.
8. Attach the tapered spacer blocks to the floor of
the sleeve. Now go to step 15.
9. Attach 1 x
x14 long seal over the solid
vertical portion of the rear grille.
10. A ttach (2) 4
x3
x1 foam blocks with the
slot over lapping the seal above.
11. Install the divider into the s lots of the foam
blocks. You may need to trim the length to size.
12. Repeat steps 9-11 for the other v ertical show n
portion of the grille as show n in the pic ture.
13. A ttach (2) 1
x1
x14 seals along the sides
of the sleeve again m aking sure all seals are
flush.
14.
15. Center unit and gently slide unit into sleeve.
16. Before sliding all-the-way back, remove 1st
sc rew from front on left side of unit.
17. Remove the plastic washer from the sc rew.
18. Screw and attach the other end of the ground
w ire to the unit as shown in picture. Make sur e
that the toothed washer is against the cabinet.
19.Slide the unit completely to the rear to ensure
a good seal, making sure the ground w ire does
not become tangled.
20.Seal & Frame the unit as described on page 17.
21
the vertical sections of the grille as
shown
C ut the 1
x1
x25 seal to fit the top of the
sleeve. The pieces m ust be fitted flush to the
edge of the div ider.
Use t hese next steps if the unit requires extra
extension into the room.
. If you have difficulty with mounting the grill to
the sleeve, follow the instructions for direct
mounting on Page 16.
Because of the increased unit depth, first try
dry fitting using the m ethod described below:
1
/
2
1
/
2
1
/
2
3
/
8
3
/
4
3
/
4
3
/
4
3
/
4
1
/
2
1
/
2
4
4
3
8
3
8
13
