3-8
TS-5020 Automotive Electronics Functional Test System Site Preparation and Installation Guide
3
Site Preparation and Power Requirements
•
On the E1135C PDU is a 25.4mm (1in) hole to install a cable
clamp and power cord. Use a power cord with a locking plug
(one that cannot be easily pulled from its outlet) or hard-wire
the system to the AC power. Customer is to provide both
cable and strain relief (see
•
To avoid electric shock, physically remove the mains plug
from the power outlet before servicing.
C A U T I O N
Verify the AC source and that service conductors are sized correctly
before connecting the system.
WA R N I N G
Electrical Shock Hazard Protection. This is a Safety Class 1
Product (provided with a protective earthing ground incorporated
in the power cord). The mains plug shall be inserted into only a
socket outlet provided with a protective earth contact.
Figure 3-4
E1135C Power Cord Installation