Keysight E6610A, User And Programming Manual

Page: 35 / 108

7 Setting up Measurements
Keysight E6610A User and Programming Guide 35
also be available from the manufacturer to connect to the RRH and send the control
commands.
From the PC start menu, search for "cmd.exe" to open a Command Prompt
window.
Type “telnet yyy.yyy.yyy.yyy” where the y’s are replaced by the IP address of
the RRH.
Log in to the RRH.
Send the appropriate commands to configure the Tx and Rx parameters of the
RRH.
Enable operation of the RRH transmitter and receiver.
Initiate E6610A Measurements
Click the green arrow to the right of the Trigger type selection to start data capture
and analysis measurements.
The default trigger type is "Continuous." You can change this to "Single shot" to
perform one capture at a time. All open measurement windows will be updated with
each capture.
The green arrow changes to a red circle while captures are occurring. Click the red
circle to stop data captures and measurement updates.