Keysight E6610A, User And Programming Manual

Page: 34 / 108

7 Setting up Measurements
Click "Open" to open the terminal window. It will be blank.
Tell the SCPI server the IP address of the E6610A by typing the SCPI command
CONTrol:INST:IPADdress xxx.xxx.xxx.xxx, where the x’s are replaced by the IP
address of the E6610A.
The SCPI server does not display a prompt, and it does not
return any response unless a query was issued. To check for
errors, use the command
SYSTem:ERRor? The SCPI server will
display any error message or respond with “No error.”
Instead of providing the IP address, you can also use the host name by typing
the command CONTrol:INST:HOST? KR12345678, where "KR12345678" is
replaced by the serial number of the desired E6610A. Note that this command
must be sent as a query with the question mark, and the SCPI server will reply
with the host name of the unit it has identified for connection.
To connect to the E6610A, send the command CONTrol:INST:CONN
To query the IP address of the RRH, send the command
CONTrol:RRH:IPADdress? Make a note of this IP address for use in sending
configuration commands to the RRH in the next step.
Establish Telnet Session to RRH
For RRHs that are controlled using command line scripts, use a telnet session to log in
to the RRH and send the configuration/control commands. Other software tools may
34 Keysight E6610A User and Programming Guide