Keysight Technologies N9330B, User Manual

Page: 23 / 107

Getting Started
Your first 10 minutes with the N9330B
17
Preparation for Use
Use
[SYS]
hardkey to set or check the system

settings of the tester.
Setting up the N9330B
Press
{Power Manager}
to enable or unable the power
saving mode. 
Pressing
[SYS] > {Power Manager (On)}
turns off the LCD
screen and key light after a pre-defined idle time set by
pressing
{Power Manager} > {Edit}
.
Press
[SYS] > {More} > {More} > {Key Light}
to turn on or
turn off the key light.
Press
[SYS] > {Language}
to select a language 
displayed on the screen.
Press
[SYS] > {Clock}
to set the time and date.
Check system status
Pressing
[SYS] > {More} > {Status}
shows the primary
information and current status of the tester.
Making the first measurement
Four easy steps:
1 Select a measurement mode.
2 Set the desired measurement range, or select a
frequency range from the list of signal standards.
3 Calibrate the tester.
4 Connect the DUT (Device Under Test) to the tester RF
OUT connector being careful not to apply a signal
which exceeds the maximum

signal levels.