Keysight Technologies N1091 CA Series, Getting Started

Page: 50 / 96

2 Installing N1091..CA and N1010A FlexDCA on a PC
50 IEEE 802.3 NRZ Compliance Test Application Getting Started
Starting the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application
After you install the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application on a PC along
with the N1010A FlexDCA interface, start the N1091..CA Series IEEE 802.3 NRZ Compliance Test
Application in one of the following ways:
Access the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application directly from the Start menu
Refer to “Starting the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application” on page 75,
where the procedure to start the application directly (that is, without launching the N1010A FlexDCA
Software) is described.
Access the N1091..CA Series IEEE 802.3 NRZ Compliance Test Application using the N1010A FlexDCA
Software on your PC
1 Ensure that the N1010A FlexDCA Software is connected to the Oscilloscope. Refer to
“Connecting N1010A FlexDCA to 86100D or N1000A” on page 43.
2 After a connection between the N1010A FlexDCA Software and the Oscilloscope is established,
the N1010A FlexDCA Software on your PC may indicate that it is remotely controlled, as shown in
Figure 50 .
Figure 50 N1010A FlexDCA under Remote Control
To view the N1010A FlexDCA's main menu, click the Local button (towards the upper right
corner).
Figure 51 N1010A FlexDCA Remote App under Remote Control