To Wall Mount a Keyphone
6.41. A base stand is used to wall mount a Keyphone. (Refer to Figures 12 and 13)
l
Position the base stand on the wall where the Keyphone is to be located with
the large wedge down, and mark on the wall the location of the two keyhole
slots.
l
Install a 6 mm x 12 mm (#8 x 0.5 inch) pan-head screw at each marked
location. Partially tighten the screws leaving approximately 6 to 8 mm protruding
(approx. 0.25 inch).
l
Attach the base stand to the underside of the Keyphone with the large wedge
down. Position the Keyphone over the two mounting screws, with the screws
inserted into the large slots in the keyholes. Slide the Keyphone down until it is
tight and stable. Adjust the handset hanger clip.
FIGURE 11: Mounting the Keyphone
FIGURE 12: Adjusting the Clip
Summary of Contents for Atlas IIE KSX 32i
Page 1: ...KSX 32i INSTALLATION MANUAL...
Page 17: ...FIGURE 2 Main Control Board MCB...
Page 36: ...FIGURE 7 Card Installation...