6.14. The following locations are to avoided as installation sites:
l
In an extremely dusty atmosphere.
l
Areas with extremes of temperature or humidity.
l
Near heat-producing or steam-producing equipment.
l
Near a passageway or aisle used for moving machinery or vehicles.
l
Away from utility or building maintenance areas.
l
Near a reproduction or copying machine, microwave ovens, electric welding
equipment, or near strong magnetic or RF fields.
Equipment Location
6.15. The equipment area should be large enough to house the equipment backboard.
The backboard will contain the cabinet and MDF. There must be sufficient space for
routing cables, servicing the equipment, and possible future expansion.
WARNING! The area should not be carpeted or have curtains or other material that
may generate static electricity. See Environmental Requirements in this
section.
6.16. The main cabinet is designed for wall mounting and must be installed so that it is
suspended from a vertical supporting surface. The cabinet should be mounted on a
backboard. A backboard of 1.2 m by 1.2 m (48 x 48 inches) is the minimum size
recommended for a full capacity system.
6.17. The wall-mounting screws used to attach the cabinet to the backboard must be
located 260 mm (10-3/16 inches) on horizontal center and must be a minimum of
710 mm (28 inches) above any obstruction.
6.18. Optional equipment should be located near the cabinet. The optional equipment
requires space for installing, so allow ample space when positioning the main
cabinet. Consider the heat generated by the equipment when calculating cooling
requirements.
Summary of Contents for Atlas IIE KSX 32i
Page 1: ...KSX 32i INSTALLATION MANUAL...
Page 17: ...FIGURE 2 Main Control Board MCB...
Page 36: ...FIGURE 7 Card Installation...