kewtechcorp.com
7. Battery Replacement
CAUTION
• Do not mix old and new batteries.
• Install batteries in correct polarity as
indicated in the Battery Compartment.
(1) Set the Function Switch to "OFF" position.
(2) Unscrew and remove the Battery
Compartment Cover on the bottom of the
instrument.
(3) Replace the batteries observing correct
polarity. Use new two
R03/LR03 (AAA)
1.5V batteries.
(4) Install the Battery
Compartment and
tighten the screw.
WARNING
• Replace the batteries when a Low Battery
Voltage warning " " mark(< 2.3±0.15V)
is indicated on the LCD. Otherwise, precise
measurement cannot be made. Note that
when the battery is completely exhausted,
the LCD goes blank without showing " "
mark.
• Do not try to replace the batteries if the
surface of the instrument is wet.
• Disconnect the test leads from the object
under test and power off the instrument
before opening the Battery Compartment
Cover for Battery replacement
.
instead of 0 when short-circuiting the test
leads. However, these phenomena doesn’t
affect measurement results.
• This instrument isn’t dust & waterproof.
• Keep away from dust and water.
• Be sure to power off the instrument after use.
• When the instrument will not be in use for
a long period, place it in storage after
removing the batteries.
• Do not expose the instrument to the direct sun,
high temperature and humidity or dewfall.
• Use a slightly damp cloth or neutral
detergent for cleaning the instrument. Do not
use abrasives or solvents.
