STEP 2
Install Mounting Brackets
1. LS0 segments attach to the mounting brackets on the underside of the luminaire. Determine location of
mounting brackets based on the center line of the segments keeping them centered along the length of the
luminaire with spacing no more than 2 ft (0.6 m) apart.
Luminaire Length
Required Brackets
4 ft (1.2 m) or less
2
4.1 ft (1.2 m) - 6 ft (1.8 m)
3
6.1 ft (1.8 m) - 8 ft (2.4 m)
4
Note: Extra brackets are provided and can be used at the discretion of the installer.
2. Mount brackets to the surface with screws.
3. When screwing mounting brackets to the surface, do not over tighten the screws. The bracket should be snug
to the surface but the center block should be able to rotate and slide up and down within the vertical slot.
INSTALLATION
Note:
After mounting, confirm that the bracket is free to slide left and right (approx. 3 in (76.2 mm) overall).
Center block
Vertical Slot
9 |
LS0
INSTALLATION GUIDE
P/N 3662707 Rev A
© 2022 Lutron Electronics Co., Inc. All rights reserved.
Summary of Contents for LS0
Page 1: ...LS0 LOW VOLTAGE LINEAR Installation Guide Models CM LS0 Coming in Phase 2 HW LS0...
Page 14: ...LS0 LIN AIRE BASSE TENSION Guide d installation Mod les CM LS0 venir dans la phase 2 HW LS0...
Page 27: ...LS0 LINEAL DE BAJO VOLTAJE Gu a de instalaci n Modelos CM LS0 que viene en Fase 2 HW LS0...
