Mähraupe HyCut
Maintenance
DE
2021-01-27
41 / 65
•
Check the track tension (see Chapter 7.7 Setting the chain tension on Page
49).
•
Carry out a trial run before each use.
•
Clean the machine after each use (see Chapter 7.9 Cleaning the machine
on Page 55).
•
Check the 12-volt and 48-volt battery voltage (see Chapter 7.8 Charging the
batteries on Page 51).
7.3.3
Maintenance after 20 operating hours / Longer periods of downtime
DANGER
Risk of death or injury due to a machine in operation!
A machine in operation can pose a risk of death and injury, as well as a risk of
material damage to the machine and system!
•
Before any maintenance work can be carried out, the machine must be
disconnected from the power supply and secured against being turned on
again. To do this, turn off the battery disconnect switch and pull it out.
The planning, execution and documentation of inspections must be performed in
accordance with all applicable laws and regulations.
In order to ensure a safe operation of the machine, all safety devices must be
checked:
Lubrication points
Personnel:
•
Private and commercial operators
Protective equipment:
•
Protective workwear
•
Protective gloves
•
Protective eyewear
•
Use grease or oil to lubricate the moving parts of the machine at regular
intervals during the season and at the start and end of each season.
•
Clean the air filter after 20 operating hours maximum and after just a few
hours in very dusty conditions.
•
Replace the air filter if it is dirty or damaged.
