770/GS/GJ-BA-defsi-0023 107
In this case, the start criterion is defined by the difference between two successive sub-
weights measured. If the animal moves, the start criterion is not met; therefore,
averaging will not start. Once the animal has calmed down, the program checks whether
two measured sub-weights are within the previously selected range. If so, the actual
averaging operation will be started.
Delay start until...
Code
difference is slight
3 7 1
difference is average
3 7 2*
difference is considerable
3 7 3
During averaging, the number of sub-weighing operations left to perform is shown on
the weight display (countdown mode).
Changing the Number of Sub-weighing Operations
The number of sub-weighing operations used to average a weight can be changed in
cycles, by you. You can choose from the following settings: 5, 10, 20, 50 and 100.
To activate this function:
Hold down the
F
key for more than 2 seconds until “
rEF
10
“ appears on the display.
To change the setting:
Briefly press the
F
key.
To store the number:
Hold down the
F
key for more than 2 seconds.
This setting is
not
cancelled by the reset function 9--1
o
!
Note
To obtain an added measure of reliability in the automatic mode in order to avoid an
“incorrect start“, a weight value must correspond to a minimum load of 100 display
increments. Once averaging has been completed, the program will stop until the
balance is unloaded to half the value (50 display increments) of the storage threshold.
