Seite / page
8
KDF 700E / 800E
Operating manual
5. Operative range and determined applica-
tion
The loor saw KDF-800E was manufactured for the purpose of cut
-
ting to a maximum depth of 320 mm in concrete, brickwork or similar
building materials. Any application other than the ones described are
to be considered illicit.
According to illustrations and information given in this manual, we
reserve the right of technical changes.
6. Transport
To push the loor saw use the telescoping handlebars, but before
doing so make sure that the bars have been tightened with the help
of the ring screws. For lifting with a crane use the jack rings.
(without blade) jack rings
(with mounted blade) jack rings
handlebars
ring screws
a
b
c
d
6.1 Removing the electric motor
To ill gasoline and oil at the engine read the corresponding chapter
at the manual.
Floor saw
Disconnect the connector of the belt guard by pulling it vertically up-
wards together with the cover cover. (A)
Loosen the nut on the threaded rod, which connects the console
plate to the low feed. Now pull the threaded rod back out of the fran-
king. (B)
Tilt the motor with the console plate as far as it is possible. You
should now be able to pull the drive belt from the belt pulley towards
you. (C)
Lift the motor and the console plate out of the machine. (D)
The motor is installed in reverse order. (E)
