11.1 Web Interface Parameters Configuration
143
Advanced parameters for the Web interface can be set upon clicking on the
Advanced
button.
Configuration of ports of the Web Interface
Use the
TCP ports
section to set ports for unencrypted and encrypted versions of the Web
interface (default ports are
4080
for the unencrypted and
4081
for the encrypted version of
the Web interface).
Figure 11.2
Configuration of ports in WinRoute’s Web Interface
Hint
If no WWW server is running on the
WinRoute
host, the standard port of the HTTP protocol (i.e.
port
80
) can be used for the unsecured web interface. In such cases, the port number is not
necessarily required in URLs for pages of the Web interfaces. However, the standard HTTPS
port (
443
) uses the
Clientless SSL-VPN
interface (see chapter
). Therefore, it cannot be used
for secured web interface in the default configuration.
Warning
If any of the entries are specified by a port which is already used by another service or ap-
plication, and the
Apply
button (in
Configuration
→
Advanced Options
) is clicked,
WinRoute
will accept this port, however, the Web interface will not run at the port and an error in the
following format will be reported in the
Error
log (see chapter
Socket error:
Unable to bind socket for service to port 80.
(5002) Failed to start service "WebInterface"
bound to address 192.168.1.10.
If you are not sure that specified ports are free, check the
Error
log immediately after clicking
Apply
to find out whether the corresponding error has been logged.
Summary of Contents for Firewall6
Page 1: ...Kerio WinRoute Firewall 6 Administrator s Guide Kerio Technologies...
Page 129: ...8 5 HTTP cache 129...
Page 404: ...404...
