4
EN
Before applying the power
Operation
When the
STANDBY
indicator is lit, the power turns ON when you press
the
POWER
key on the remote control. When the power comes ON,
press the key you want to operate.
• When pressing more than one remote control key successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2. When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
Preparing the remote control
Loading the batteries
1
Remove the cover.
2
Insert the batteries.
3
Close the cover.
• Insert two AAA-size (R03) batteries as indicated by the polarity
markings.
Operating range
(Approx.)
Remote sensor
Infrared ray system
Unpacking
Unpack the unit carefully and make sure that all accessories are
present.
FM indoor antenna (1)
AM loop antenna (1)
Remote control unit (1)
Batteries (R03/AAA) (2)
RC-R0516E (for the Europe)
RC-R0516 (except for the Europe)
FM antenna adapter (1)
If any accessories are missing, or if the unit is damaged or fails to operate,
notify your dealer immediately. If your unit was shipped to you directly,
notify your shipper immediately. Kenwood recommend that you retain
the original carton and packing materials in case you needs to move or
ship the unit in the future.
Keep this manual handy for future reference.
Channel space switching
(Except for the Europe and Australia)
The space between radio channels has been set to the one that
prevails in the area to which the system is shipped. However, if the
current channel space setting does not match the setting in the area
where the system is to be used, for instance when you move from
area 1 or area 2 shown in the following table or vice versa, proper
reception of AM/FM broadcasts cannot be expected. In this case,
change the channel space setting in accordance with your area by
referring to the following table.
Turn the power OFF by pressing the POWER key before moving the
switch level. Move the switch lever to match your area with a small
screwdriver or other pointed tool, then turn the power ON again.
1.
2.
CHANNEL
Space Frequency
Area
U.S.A., Canada and South
American countries
Other countries
FM: 100 kHz
AM: 10 kHz
FM: 50 kHz
AM: 9 kHz
FM
75
Ω
AM
GND
SURR BACK
/SW
REAR
FRONT
CENTER
L
R
L
R
SPEAKERS (6 – 16
Ω
)
ANTENNA
VIDEO1
VIDEO2
DVD
SUB WOOFER
SURR BACK
PRE
OUT
L
R
L
R
IN
OUT
AUDIO
VIDEO2
IN
DVD
IN
S VIDEO
VIDEO
MONITOR
OUT
MONITOR
OUT
VIDEO1
IN
OUT
COAXIAL
OPTICAL
VIDEO1
VIDEO2
DVD
DIGITAL IN
VOLTAGE SELECTOR
AC110-
120V~
AC 110-120V
/220-240V~
50/60Hz
W
AC220-
240V~
DE-EMPHASIS
CHANNEL SPACE
50
µ
s
AM9kHz
FM50kHz
75
µ
s
AM10kHz
FM100kHz
R
/L
BS
DE-EMPHASIS
CHANNEL SPACE
50
µ
s
AM9kHz
FM50kHz
75
µ
s
AM10kHz
FM100kHz
名称未設定-6
04.3.25, 4:46 PM
4
